61
Here are descriptions of every setup items:
Disable/Enable (1): There are three selections for disable or disable
wireless ISP functions.
Disable: disable this function.
Enable: enable this function and the router can connect
to the access points installed by your wireless service
provider. Any clients associated to the router can
access the Internet service through the wireless
network.
Note: In this mode, if you are informed by your
wireless ISP that the wireless settings of the access
point is changed, please configure the router in this
page for match the settings.
SSID (2): This is the name of wireless network. Input the SSID
name that your wirelesses ISP provide to you.
Site Survey (3): Click ‘Select Site Survey’ button, then a “Wireless Site
Survey Table” will pop up. It will list all available access
points nearby. Select the access point designated by
your wireless ISP in the table and the router will join
wireless network through this access point.
Security Settings (4): If the access point enables wireless security, you have
to follow the same settings in order to access the
access point. Click to set security settings for this
connection (Please go to section ‘2-7-3 Wireless
Security’ for detailed instructions).
To Next Page
Loading...
