92
Operating Other Devices
Chapter 10
Programming to Control a Second Satellite Receiver
If you have another DISH satellite receiver installed in your home, you can use the remote
in AUX mode to control it along with your new receiver. When you program the remote to
control another receiver, the remote will send out IR signals to the receiver so the line-of-
sight to the second receiver must be unobstructed. You can program the remote to control
most other DISH receivers except the following models:
• You cannot control TV2 programming on a DISH 322, ViP222, ViP222k, ViP622 DVR,
ViP722 DVR, ViP722k DVR, DISH Player-DVR 522, 625, and 942 receivers.
• The DishPlayer 7100/7200 receiver cannot be controlled by current-model remotes.
1 Turn on the other receiver and use the front-panel button to display its System Info screen.
Write down the receiver’s address:
2 Press and hold the AUX mode button until all the other mode buttons light up, and then
release AUX. The AUX mode button flashes.
3 Press the 3 button on the remote control’s NUMBER PAD.
4 Use the NUMBER PAD on the remote to enter the address you wrote in step 1.
5 Press the remote control’s POUND (#) button. The AUX mode button blinks three times.
6 Press RECORD and ensure the remote control’s address matches the address displayed
on the receiver.
To Next Page
Loading...
