82
Operating Other Devices
Chapter 10
Programming Using Device Code Tables
Set up the remote to control other devices using the manufacturer codes listed with your
DISH remote. In the instructions below, the column on the left contains basic procedures
to perform and the column on the right provides any additional information, if applicable.
Instructions Additional Information
1 Turn the device on.
Use the device’s front panel buttons or its own
remote control.
2 Find the brand name of the device in the
tables included with your remote control.
If the brand isn’t listed, see Programming Using
Device Code Scan on page 83.
3 Press and hold the mode button until all the
other mode buttons light up, then release
the button. The mode button flashes.
For example, for a TV, press and hold the
TV mode
button until all of the other mode buttons light. When
you let go of it, the TV mode button will flash.
4 For AUX mode only. Press 0 for a TV, 1 for
a VCR, or 2 for a tuner or amplifier.
If you’re not programming in
AUX mode, skip to
step 5.
5 Enter one of the three-digit device codes
from the table using the
NUMBER buttons.
The three-digit device code is for the brand name of
your device that you found in step 2.
6 If you want to program Limited Mode,
press 1. If not, skip to step 7.
See Limited Mode for more information.
7 Press the POUND (#) button.
If you entered the code correctly, then the device
mode button flashes three times.
8 Press POWER to turn off the device. If the
device does not turn off, go to step 10.
If the code works, then the device should turn off.
9 Turn the device back on and try some other
buttons to make sure they work. If the code
works for other buttons, you can stop here.
Sometimes
POWER works when other buttons
don’t. If in Limited Mode, try
VOLUME or MUTE.
10 If the code doesn’t work, repeat steps 3
through 9 with another device code from
the tables.
Try every code listed in the tables for your brand
until one works for your device.
11 If you can’t find a code that works, then try
Programming Using Device Code Scan on
page 83.
To Next Page
Loading...
