Chapter 2
Page 8
Monitor Description
Remote Control Buttons
The following section describes how to use the remote control with your
monitor.
Mode Buttons
The mode buttons on your remote control allow you to control your
monitor, DISH Network satellite receiver, and other devices.
• Press the SAT mode button to turn on the monitor and DISH Network
satellite receiver, and change the monitor to the DISH DVI input so
you can watch satellite programming.
This action also puts the remote control into the SAT mode, enabling it
to control the satellite receiver. Refer to your satellite receiver User’s
Guide for how to control your satellite receiver.
• Press the TV mode button to control the monitor. See the section below
for details on monitor controls.
• Press the VCR and AUX mode buttons to control other devices. See
page 31 for instructions on autotuning the monitor to display from
these devices when these mode buttons are pressed.
See the User’s Guide that came with your DISH Network satellite
receiver for instructions on using the mode buttons to program the
remote to control other devices.
TV Mode Button
Pressing the TV mode button puts the remote control in the TV mode.
When in the TV mode, the other buttons work as described below to
control monitor features.
Note: Your remote control provided with your DISH DVI-equipped DISH
Network satellite receiver comes from the factory ready to work with your
DISH Network HDTV monitor. However, the TV mode button can be
programmed to operate other TVs. If the remote control has been
programmed to operate a different TV and you wish to restore the remote
control factory settings to control your DISH Network HDTV monitor, see
Restoring Your Remote Control’s Factory Settings for Monitor Control on
page 38.
Tip: Normally,
you would want
to use the remote
control in SAT
mode to watch
DISH Network
programming
and to use the
extensive fea-
tures of your
DISH Network
satellite receiver.
To Next Page
Loading...