Service - 102 C16x/C24x/C30x Operator’s Manual
As Needed
Set up and Check
1. Park service vehicle close to defective equipment but do not allow vehicles to touch.
2. Engage parking brake in both vehicles.
3. Turn the ignition switch to the OFF position in both vehicles, and turn off all electrical loads. Disconnect
the machine controller.
4. Inspect defective battery (B) for signs of cracking, bulging, leaking, or other damage. If battery is
damaged in any way, do not jump start. Replace battery.
5. Check for loose or corroded battery cable connections.
6. Carefully clean terminals and posts.
Acid in battery is corrosive. Contact with skin will cause
burns.
To help avoid injury:
• Avoid contact with battery fluid.
• Wear applicable safety glasses and gloves.
• See Material Safety Data Sheet (MSDS) for additional information.
To Next Page
Loading...
