Saw - 102 RT45 Operator’s Manual
Setup
Setup
1. Fasten and adjust seatbelt.
2. Start tractor. See page 72 for start-up procedures.
3. Drive to starting point. Move in line with planned job. See page 74 for driving procedures.
4. Set parking brake.
5. Move ground drive control to low.
6. Lower saw to just above ground. See “Saw Controls” on page 44 for information on operating saw.
7. If equipped with traversing saw, set at desired offset position.
EMERGENCY SHUTDOWN - Turn ignition switch to STOP.
Crushing weight could cause death or serious injury. Use
proper procedures and equipment or stay away.
To help avoid injury: Use attachments or counterweights to make front and rear loads balance when all
attachments are raised. Contact your Ditch Witch
®
dealer about counterweighting for your equipment.
Jobsite hazards could cause death or serious injury. Use
correct equipment and work methods. Use and maintain proper safety
equipment.
To help avoid injury: Comply with all utility notification regulations before digging or drilling.
Read operator’s manual. Follow safety rules and know
how to use all controls. Your safety is at stake.
273-475
To Next Page
Loading...
Need help?
General
