Service - 182 RT45 Operator’s Manual
As Needed
Time Augers
Ensure that augers are balanced, as shown. If
auger timing is off, unit will bounce from side to
side even in normal digging conditions.
To adjust timing:
1. Remove bolts holding augers to auger shaft
and rotate either auger as needed until
augers are balanced.
2. Reinstall bolts and tighten securely.
Inspect Seat Belt
Check seat belt and mounting hardware as
needed. Inspect the webbing, buckle and latch,
retractor, and mounting hardware.
Buckle and Latch
Check that the buckle and latch (1) are not broken
or corroded. When inserting the latch into the
buckle, the latch should insert smoothly until an
audible click is heard. Latch should not release
when the seat belt is tugged.
Webbing
Inspect seat belt webbing (2) to ensure that it is
not cut, frayed or showing signs of extreme or
unusual wear. Check the area near the buckle
and latch and anywhere the seat belt has contact
with equipment or seat.
Retractor
Check that the retractor (3) operates smoothly when the belt is pulled and released. Retractor should spool
belt without locking.
Mounting Hardware
Inspect the seat belt mounting bolts (4) on both sides of the seat to ensure they are tight. Replace missing,
damaged, or corroded bolts.
22
11
11
33
44
SeatBelt.epsSeatBeltService.eps
To Next Page
Loading...
