DITEC LCA85 - Maintenance

IP2371EN
ASSA ABLOY Entrance Systems AB
Lodjursgatan 10
SE-261 44, Landskrona
Sweden
© ASSA ABLOY
Problem Possible cause Alarm signal-
ling
Operation
External safety
devices not acti-
vating
Incorrect connections between
the photocells and the control
panel.
Check that
/ is displayed
Connect NC safety contacts together in
series and remove any jumpers on the
control panel terminal board.
Check the
→ and →
setting
The automation
opens/closes
briefly and then
stops.
There is a presence of friction.
Manually check that the automation
moves freely and check the
/
adjustment. Check that the limit switches,
if installed, are working correctly Contact
Technical Service
The remote control
has limited range
and does not work
with the automa
-
tion moving.
The radio transmission is im-
peded by metal structures and
reinforced concrete walls.
Install the antenna outside.
Replace the transmitter batteries.
The remote
control does not
work
No storage module or incorrect
storage module.
Switch the automation off and plug in the
correct storage module.
Check the correct memorisation of the
transmitters on the built-in radio. If there
is a fault with the radio receiver that is
built into the control panel, the remote
control codes can be read by removing
the storage module.
13. Maintenance
The control panel doesn't require any special maintenance.
Make regular checks to ensure the seals on the box and the electrical connections are in good
condition.
All the rights concerning this material are the exclusive property of ASSA ABLOY Entrance Systems AB. Although
the contents of this publication have been drawn up with the greatest care, ASSA ABLOY Entrance Systems AB
cannot be held responsible in any way for any damage caused by mistakes or omissions in this publication.
We reserve the right to make changes without prior notice.
Copying, scanning or changing in any way is expressly forbidden unless authorised in writing by ASSA ABLOY
Entrance Systems AB.
The crossed-out wheelie bin symbol indicates that the product should be disposed of separately from
normal household waste. The product should be recycled in accordance with local environmental regulations
for waste disposal. By separating a product marked with this symbol from household waste, you will help
reduce the volume of waste sent to incinerators or land-fill and minimise any potential negative impact on human
health and the environment.