EasyManuals Logo

DITEC LCA85 User Manual

DITEC LCA85
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
42
IP2371EN
NOTE: make adjustments gradually and only after performing at least three complete oper-
ations to allow the control panel to be set correctly and detect any friction during operations.
Display Description Selections available
LU - Setting switch-on time for courtesy light (s)
To enable this parameter, set at least one of the selections
or
as a courtesy light.
It is set with different intervals of sensitivity.
NO - Disabled
- from 01” to 59” with intervals of 1 second
- from 1’ to 2’ with intervals of 10 seconds
- from 2’ to 3’ with intervals of 1 minute
ON - Permanently enabled (switched off via remote control)
NOTE: the courtesy light switches on at the start of each operation.
LG - Switch-on time for independently commanded courtesy light [s]
To enable this parameter, set at least one of the selections
or
as a courtesy light.
It is set with different intervals of sensitivity.
NO - Disabled
- from 01” to 59” with intervals of 1 second
- from 1’ to 2’ with intervals of 10 seconds
- from 2’ to 3’ with intervals of 1 minute
ON - Switched on and off with remote control
NOTE: the switching on of the light does not depend on the start of
an operation, but can be commanded separately using the special
remote control key.
PT - Fixed partial opening
ON - Enabled
OF - Disabled
If ON, a partial opening command given on the partial opening position is
ignored. With contact 30-20 closed (for example with the timer or manual se
-
lector), the gate will partially open. If it is then fully opened (command 30-3) and
reclosed (even with automatic closing), it will stop at the partial opening position.
DE - Disengagement duration if an edge is triggered [s]
Regulates the duration of the disengagement when an edge (active) is
triggered during opening or closure.
00 - Disable.
1.0
9.9.1 Additional configurable AP level parameters available with
enabled
AP - Advanced parameters

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DITEC LCA85 and is the answer not in the manual?

DITEC LCA85 Specifications

General IconGeneral
BrandDITEC
ModelLCA85
CategoryControl Panel
LanguageEnglish

Related product manuals