PROBLEM
AFTER ACCIDENTALLY CLOSING THE QUICK-STRIP LATCH, WHILE THE MARKER’S HPA SYSTEM WAS
TURNED ON, THE LUXE
®
HAS A SLOW, CONTINUOUS LEAK.
SOLUTION
Disassemble the Quick Strip Plug [FIG. 1] following the instructions in this manual, and replace the
damaged degassing core o-rings
PROBLEM
LUXE
®
WILL NOT TURN ON WHEN POWER BUTTON IS DOUBLE-PRESSED.
SOLUTION
Recharge the Luxe
®
battery [FIG. 2] following the instructions in this manual (see HARDWARE 3.6.)
Following the battery replacement instructions (see HARDWARE 3.6,) ensure that the battery is installed
and connected securely to the Luxe® circuit board.
PROBLEM
FIRST SHOT FIRED HAS LOW VELOCITY BUT STABILIZES WITH FOLLOWING SHOTS (FIRST SHOT DROP-
OF F.)
SOLUTION
Clean, inspect and lubricate the Luxe
®
Power Core and bolt spring (see MAINTENANCE 5.1.)
Increase FSD Compensation setting (see SOFTWARE 4.6)
PROBLEM
LUXE
®
WILL TURN ON AND MAKES PUFFING SOUND WHEN TRIGGER PULLED BUT WILL NOT FIRE.
SOLUTION
Make sure that the Dwell setting is set to the default value or higher (see SOFTWARE 4.6.)
Clean the Power Core, and replace and lubricate the fire chamber’s inner o-rings. (see MAINTENANCE 5.1.)
PROBLEM
VELOCITY DROPS OFF DURING RAPID FIRE.
SOLUTION
Clean, inspect and lubricate the Luxe
®
Power Core (see MAINTENANCE 5.1.)
FIG.
FIG.
ADVANCED MAINTENANCE 6.12 TROUBLESHOOTING
FOR MORE IN-DEPTH TROUBLESHOOTING AND REPAIR TIPS, VISIT LUXEPAINTBALL.COM.
To Next Page
Loading...
