STEP FIVE INSTALL YOUR LOADER (SOLD
SEPARATELY)
THE ANTI-CHOP VISION™ SYSTEM IN YOUR LUXE
®
will
allow it to work with any loader. Best performance and
highest rate of fire however, will only be possible with a
high performance force-feed loader system. Open the
marker's locking feedneck by pulling the lock lever away
from the neck, then insert the loader and secure it in place
by folding the lever back to its locked position. Loader
necks vary in size from brand to brand. If the loader does
not fit securely or the lock lever does not easily close,
see Orientation 1.3 in this manual for feedneck clamp
adjustment instructions.
STEP SIX TURN ON AIR
GENTLY GAS UP YOUR LUXE® BY
SLOWLY
PULLING the
Luxe
®
bottom-line charging handle back to the on position,
folding it into the body of the ASA. This will depress the
valve pin on your air system.
A GENTLE RISE IN PRESSURE IS IMPORTANT, AS A SUDDEN
BLAST MAY REDUCE THE SERVICE LIFE OF PRESSURE SEALS
WITHIN YOUR LUXE®.
The Luxe
®
bottom-line charging handle must be turned
off (pulled out) before removing screw-in compressed air
systems.
AIR OFF
AIR ON
STEP FOUR FILL & INSTALL YOUR AIR
TANK (SOLD SEPARATELY)
YOUR LUXE
®
IS DESIGNED TO OPERATE PROPERLY
with high pressure compressed air (HPA—also commonly
referred to in paintball as nitrogen or nitro) as its
power source. Have your air system filled, following its
manufacturer’s directions. Pull the Luxe
®
bottom-line
charging handle out and forward to the off position, then
screw the air system into the back of the ASA.
4 5 6
To Next Page
Loading...
