i
OPERATOR’S INSTRUCTION MANUAL
METAL CUTTING BAND SAW
For your information and future reference, pertinent data concerning your machine should be written
in the spaces provided above. This information is stamped on a plate attached to your machine. Be
sure to provide machine model and serial number with any correspondence or part orders.
Specifications contained herein were in effect at the time this manual was approved for printing. The
DoALL Company, whose policy is one of continuous improvement, reserves the right, however, to
change specifications or design at any time without notice incurring obligations.
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATING THE MACHINE!
For sales, parts and service call +31 78 652 6060, or e-mail info@doall.nl
For general information, please visit our website at: www.doall.nl
DoALL Europa B.V.
Debijestraat 14
3316GE Dordrecht, NL
The following registered trademarks of the DoALL Company are used in this manual: DoALL.
PRINTED IN THE NETHERLANDS
To Next Page
Loading...
