DoAll C-4033NC - Band Wheels; Cleaning Chip Conveyor

 37

WEARPLATEREPLACEMENTS(Continued….)

Visejawwearplates

1. Themachinehaseight(8)visejawwearplates:four
(4)onthefrontvisejawsandfour(4)ontheindex
vise jaws. All wear plates are mounted with low‐
headscrews.Besurethevisejawsareseparated
andthemachineturnedoffbeforetryingtoreplace
thewearplates.
Viseguiderails
1. Each ofthe two (2) vise guide railsfor bothfront
andindexviseshaseight(8)mountingscrewswhich
mustberemoved.Replacementrequires:(a)
removing the mounting screws; (b) pulling the
guiderailstowardstheleft.

BANDWHEELS

1. Occasionally check each band wheel’s back‐up
flangeandwheelthreadforwear.Sawbandwillnot
trackproperlyifthetaperiswornfromthewheel
thread.
2. Replacetheentirebandwheeliftherimbecomes
badlyworn.
3. Ideally, the saw band should be tracking on both
wheelssothatthebackedgewilljustlightlycontact
thewheelflangesorrun‐offmaximum1to2mm.

CLEANINGCHIPCONVEYOR

1. To cleanthechipconveyor,turnthe machineoff.
Then: (a) disconnect the hydraulic hoses; (b) pull
theaugerfromitscradledpositioninthemachine
base;(c)cleanthechipconveyortrough;(d)clean
thereservoir floor; (e)reinstall the augerand the
cover.
