1
SAFETY RULES
1. CLOTHING. To protect from
entanglement or being pulled by a
clamped vise, the operator should not
wear loose fitting clothing or wear
gloves while operating the machine.
Wear safety shoes to protect against
foot injury.
2. INSTALLATION. The machine must be
properly grounded to protect against
electric shock. Use durable insulating
material to protect power lines that lie
on the floor.
3. DO NOT defeat the purpose of any
guards or any other safety devices.
THEY ARE THER FOR YOUR
PROTECTION.
4. Keep hands away from moving saw
blade while running the machine.
5. If the operator needs to check the
interior of the machine during operation,
turn the machine off and wait until the
machine comes to a complete stop.
6. DO NOT enter the index vise moving
area. Lifting of workpieces to the
feeding table is done by overhead hoist.
7. DO NOT touch the circuit breakers,
switches or buttons with wet hands.
8. Turn power off before servicing,
cleaning or maintenance.
9. Wear gloves when replacing the saw
blade, removing chips, replacing cutting
fluid or when moving material.
10. Coolant is no edible. If swallowed,
immediately spit it out and rinse the
mouth thoroughly.
11. DO NOT operate, maintain or check the
machine under the influence of alcohol
or medication.
12. The machine will stop when a door or
guard is opened. Wait until the machine
comes to a complete stop before
entering the area.
13. DO NOT stand on the front or rear
supporting rollers.
14. Periodically perform a machine check
before starting. After completing a job,
clean both the machine and the work
area thoroughly.
15. The machine operator must be trained
and must understand the operation,
lifting, saw blade replacement and
maintenance of the machine.
16. Maintenance personnel must be trained
and knowledgeable of electrical control
systems.
17. This machine is designed to cut steel
bars and profiled tubes only. Do not cut
food, wood, plastic, poisonous material,
magnesium or its alloys.
To Next Page
Loading...
