INSTALLATION
2-16 L025317 Issue 1 March 2011
The Shaft Encoder input is directly connected in parallel with the Product
Detect Interface. For this reason the electrical specification is identical as well.
For the same reason, the standard encoder cable has no “Z” connection in
order not to get signal collision with the product detector. If needed e.g. in
labeller applications, the isolated leads may be soldered to the scheduled pins,
or a fully connected cable (Z- version) may be ordered.
Three different types of shaft encoders can be connected:
•NPN-types,
•PNP-types
• and differential types.
To Next Page
Loading...