INSTALLATION
2-18 L025317 Issue 1 March 2011
The machine interface delivers inputs and outputs to control the print process
and provides status information. It can be used to communicate with a PLC
or to harness external NPN or PNP type control elements.
Connector Type: IEC 60130-9 12 way male
Mating Cable Connector (IP67 Types) :
• Lumberg: 032212
Pin description
Pin A +24VF - 24V floating
This pin offers 24V floating. The maximum current for X4 and X28 is 0.5A.
In case of an overcurrent an automatic resetable fuse protects the system
Pin B GNDF - Floating Ground
Pin C INP_COM - This pin is defined as common pin for all inputs.
Pin D LASER_START - Mark enable input,
A logic high level on this pin puts the system into print mode and resets error
messages. The laser is enabled.
Note: This input is internally working in parallel to the other (X29 and X59)
Laser Start Inputs. Thus, applying of constant voltage at this pin will
suppress edges coming from the other Laser Start Inputs.
Pin E MARK_CTRL - Mark inhibit / release input
A logic high or low level at this input enables or disables the Print_Go signal
delivered by pin F of the X4, pin 6 of X29 or pin3/4 of X3. The active level
can be selected by software.
Pin F PRINT_GO - Print Start input
A rising or falling edge at this input starts the print. The active level can be
selected by software.
Pin G PROG_IN - Programmable Input
This input is prepared for future use.
To Next Page
Loading...
Need help?
General