5. About the engine
80
9
EF.120-208 Pis-
ton Ring Com-
pressor
First, assemble the connect-
ing rod and piston rings to
the piston.
Then, insert the connecting
rod of the piston assembly
into the tool from tapered
part of the tool, and push
the pistoon until the piston
is still in the tool.
Place the tool with the pis-
ton assebly onto the liner
hole.
(Before this, inser the con-
necting rod of the piston
assembly into the liner
hole.)
Assemble the piston assem-
bly by pushing the upper
part of piston into the cylin-
der liner through the tool
until it is passed the tool
completely.
10
EF.123-365 Cyl-
inder Liner
Puller
First, place the tool onto the
cylinder block, and insert
"T" shape plate of the tool
into the cylinder liner and
hook it on the bottom of the
cylinder liner.
Pull out the cylinder liner by
turning the hexagonal nut of
the tool.
11
60.99901-0027
Feeler Gauge
Determine the gaps of the
valves or back lash of the
gear, etc.
12
EF.200-038
Chain Plier
First, wind the chain of tool
around oil filter cartridge
and adjust the length of
chain adequately by turning
adjustable screw of the tool.
Second, grip the lever of
the tool and detach the car-
tridge by rotating the tool
counerclockwise.
No.
Product Num-
ber
Shape Application Work Tips
To Next Page
Loading...
