13. Installation Guidelines
200
Heater
50 Hz heater 195 W x 2 assembled optionally with the pre-filter.
• Circuit Diagram: Voltage (24 VDC), Watt (195 W), Amps (4.5 A ±0.4 A)
• The bimetallic heater is connected to a separate on/off switch on the generator control panel and is used for cold starts.
Fuse and Relay Connections
EDX22190144
87A
30/51
85
86
87
Relay
Battery Heater
Fuse Connection
Key Controlled
Switch
Thermo-Switch
25A
Fuse
Relay Connection
Key Controlled Switch
Sensor Description Note
Heater lead wire:
Connector Housing PACKARD #12103584
Pin PACKARD #12124581-L
To Next Page
