4. Regular Inspections
39
Adding Engine Oil
1. Drain the engine oil.
EDX22190039
1) Place a container for draining the engine oil under the
engine.
2) Turn the drain handle on the side counterclockwise to
drain the engine oil.
3) Drain the engine oil using either the drain handle (A) or
the drain plug (B).
2. Replace the oil filter.
EDX22190040
1) Use a filter wrench to remove the oil filter.
2) Wipe off the head and cartridge contact surface of the oil
filter thoroughly.
3) Make sure the oil filter cartridge is seated properly.
4) Apply a thin layer of oil to the O-ring on the cartridge.
5) Temporarily tighten the new oil filter by hand.
6) Use a filter wrench to finish tightening the oil filter.
3. Add engine oil.
EDX22190041
1) Install the drain plug.
2) Add the specified amount of engine oil through the oil
filler port.
3) Check that the oil level is at the upper limit mark on the
dipstick.
4. Once this is complete, perform a final inspection.
1) Idle the engine for a few minutes to distribute oil
throughout the lubrication circuit of the engine.
2) Stop the engine and wait approx. 10 minutes.
3) Check the oil level and add oil if necessary.
• When replacing the oil filter cartridge, make sure to
use a new genuine Hyundai Doosan Infracore
cartridge.
• The new oil filter must not contain any oil when it is
installed. Do not fill the new oil filter with oil from the
old oil filter.
While adding oil, be careful not to allow dust or foreign
matter to enter the system.
Adding engine oil past the upper limit on the oil level
gauge may cause engine faults. If engine oil is filled past
the upper limit, the engine oil must be drained until the
oil level lies between the upper and lower limits on the
oil level gauge.
To Next Page
Loading...
