G424F(FE) Service Manual Chapter 5. Engine Management System (EMS) 164
Installation
1. Install new O-ring on CMP sensor.
2. Lubricate O-ring with clean engine oil.
3. Install the CMP sensor into the CMP sensor
support plate.
Note: Before installing retaining screw, verify the
CMP sensor is fully seated.
4. Install retaining screw and lock washer. Tighten
retaining screw.
Tighten
• Bolts: 6 N•m(53lbf in).
5. Connect the electrical connectors. Verify that the
connectors click/lock into place.
6. Install harness clamp to CMP sensor support
plate.
To Next Page
Loading...
