G424F(FE) Service Manual Chapter 3. Engine Mechanical System 44
14. Connect wiring to the injectors.
15. Connect the PCV hose between PCV and fitting.
16. Hose clamp with torque driver; tighten.
Tighten
• Clamps: 1. – 1.5 N·m (0.75 – 1.1 lb·ft.).
17. Bracket-stay and its attaching nuts, without
tightening.
18. With a 17-mm torque spanner; tighten.
Tighten
• Nuts: 35– 40 N·m (25.8 – 29.5 lb·ft.).
19. A new gasket between mixer assembly and
intake manifold.
20. Mixer assembly and its attaching nuts, without
tightening.
21. With a 5mm hex-bit socket wrench and torque
wrench; tighten by using thread locker.
To Next Page
Loading...
