Using the on-screen display
USB hub menu
NOTE
On model ES07D03, to access this menu, Spectrum must be updated to firmware version
108 or newer. Some features may still be available elsewhere in the OSD.
Host device override
Forces the monitor to ignore individual port settings and always use either the USB Type-B or Type-
C port to connect to the built-in USB hub to its upstream host device. When set to ‘Off’, the USB
source switches automatically based on the individual port settings below.
Type-C host device
Selects from which port the USB hub upstream host device is connected, when the USB Type-C port
is the active video signal input port.
DisplayPort host device
Selects from which port the USB hub upstream host device is connected, when the DisplayPort port
is the active video signal input port.
IMPORTANT
Do not switch between USB upstream ports while a storage device connected to the
downstream ports is in use, as this may cause data loss. For the same reason, it is not
recommended to enable automatic USB hub host switching in the OSD menu if storage
devices are attached to Spectrum’s downstream ports.
NOTE
By default, you can quickly cycle through the various USB host device settings by pressing
the joystick down when the OSD menu is not active.
If the firmware currently installed does not contain the ‘USB hub’ menu, the ‘Host device
override’ feature may be found in the ‘Input/Output’ menu as ‘Select USB hub source’. We
recommend installing the latest firmware to unlock the full suite of USB hub customization
options.
To Next Page
Loading...
Need help?
General
