Quick actions
If the OSD menu, crosshair overlay, and frame rate counter overlay are not active, pressing the
joystick in any direction will perform quick actions. This lets you quickly enable or disable features,
or cycle through available options:
• Pressing down will cycle video input sources.
• Pressing up will cycle USB hub input sources.
• Pressing left will enable or disable the frame counter overlay.
• Pressing right will enable or disable the crosshair overlay.
NOTE
These quick actions are not available when Spectrum is in standby mode. Depressing the
joystick will temporarily activate the monitor and allow the changing of video- and USB hub
input sources.
On model ES07D03, some of these quick actions are only available when using firmware
version 106 or newer.