Appendix F- Icon Glossary (cont.)
Sensor Alarms in the Alarm Calendar
Alarm Ended But
Not Acknowledged
Part numbers and description that
would be associated to the conditions.
Icon only seen during
auto-detection
process to show
sensor type.
Icon outlined with a
dotted red line and
red triangle. Occurs
when an alarm
condition is seen
Icon outlined in blue
with red triangle.
Occurs when user
clicks on alarm in
alarm screen.
Icon outlined in blue
and triangle is blue.
Occurs when alarm
has ended but has
not been
acknowledged.
Icon completely gray.
Occurs after alarm
has been
acknowledged and
the alarm event has
ended.
Displayed when the
item is currently
unavailable. Icon is
completely grayed.
Dual Float STP Sump Sensor: 30-0232-D-20
High-Level Alarm:
Occurs when the upper and lower
floats are above the threshold for the
alarm condition.
Low-Level Alarm:
Occurs when the bottom float is above
the threshold for the alarm condition.
Disconnect Alarm/Communication
Loss:
Occurs when the sensor has been
disconnected from the barrier or the
sensor fails.
Dual Float Brine Sensor: 30-0232-D-10B
High Level Alarm:
Occurs when the upper and lower float
is above the threshold for the alarm
condition.
NOTE: When sensors are added manually to the system when using non-smart sensors or adding sensors to a VSmart Module, the icons will have a little man in the
upper-left-hand corner of the icons, as shown to the right.
To Next Page
Loading...
