4.5.6 Finishing the Flex Probe Installation
25. Connect the probe wiring bushing ½-inch NPT to the
junction box using a short length [18 inches (45.7 cm) max]
of flex conduit.
26. Connect the probe to the cable in the junction box and
console as below.
27. Verify that the probe is operating correctly at the console.
28. Waterproof the probe connections at the junction box with
the epoxy seal-pack and close the junction box.
Figure 4-7 Finishing the Flex Probe Installation
Figure 4-8 Flex Probe Component Diagram
To Next Page
Loading...
