Connecting Directly via Crossover Cable
To connect to the console directly using a crossover cable, connect a
crossover cable from a PC directly to the SiteSentinel® iSite
Ethernet
port. Once this is done, the user’s PC will come up with a message
stating “limited or no connectivity.” This is normal. Once the cable is
connected, the user can log into the SiteSentinel® iSite
and go the
settings>system>networking to the SiteSentinel® iSite
IP address.
Once the IP address is found, enter that IP into the address bar of the
Internet browser. This should bring up the SiteSentinel® iSite
login
screen. The user may now login and explore/configure the
SiteSentinel® iSite™.
If the SiteSentinel® iSite
or PC is setup to static IP, it must be
either changed to DHCP or set the PC to 1 IP below or above the
SiteSentinel® iSite™ IP address in order to connect.
Error: Limited or No Connectivity
Once the IP address is found and recorded, enter this IP address into
the address bar on Internet Explorer and press Enter to access the
page. This will load the login screen for the console. Once logged in,
you will have the same access as if you were pressing the screen on
the console.
Not all Utilities functions are available with a remote connection.
Connecting USB Keyboard
If you do not want to use the on-screen keyboard for configuring the
system you can connect a USB keyboard to the system for
configuration purposes. Plug in the USB keyboard to one of the
external USB ports for instant use of the keyboard.
There is a PS2 port on the inside of the console if you do not have a
USB keyboard available. See Appendix J: Console Boards for the
location of the port. In most cases the system will need to be
rebooted to recognize a keyboard plugged into this port.
Other connections used for polling POS information:
•
via FSC3000
passthru 20-1613
•
via System2
passthru 20-1456
•
direct serial 20-1520-05
To Next Page
Loading...
