Dover OPW SiteSentinel iSite - Dual Level Reservoir Sensor

Page 130 of 145
www.opwglobal.com
Dual Level Reservoir Sensor
Part # 30-3221-2
The Dual Level Reservoir Sensor is designed for use in the brine-filled
reservoir of the interstitial area of a double-walled tank. This sensor
contains a dual-level float switch that detects level changes of fluid in
the reservoir of the tank. The sensor expects the liquid to be at a
constant level. The system will activate the alarm when the brine level
in the interstitial space either rises or falls.
It can also be used in other areas (such as dispenser containment
pans) that are normally dry and will give a low-level warning followed
by a high-level alarm. In the event of a break in the cable, the system
will activate the alarm.
Dual Level Reservoir Sensor
Dual Level Reservoir Sensor
Substance Detected:
Liquid
Operating Temperature:
-4°F to 122°F (-20°C to +50°C)
Dimensions:
2.4” x 14” (6 cm x 35.6 cm)
Required Cable:
15’ (4.6 m) gas-and-oil resistant cable
Maximum Wiring Length*:
1,000’ (305 m)
Multi-Drop Restriction:
1 per channel
Connections:
Red = Power, White = Signal
*Maximum Wiring Length is the maximum length of cable to be used
to connect all sensors on an individual channel. The length includes
run of cable from VSmart to each sensor board in the string.