12.2
Model EECO Probes
CANNOT BE MULTI-DROPPED ON VSmart.
The Model EECO Probe is primarily used in underground storage
tanks for inventory and leak detection. Two floats can be fitted to the
probe shaft; the product float sits on top of the product and the water
float (optional) sinks through the product and sits on top of the water at
the bottom of the tank.
Magnetostrictive with Floats
From 4’ to 16’, in 6-inch increments
Level
Precision:
Accuracy:
± 0.0005” (.01 mm)
± .05% Full Scale or 0.006” (whichever is greater)
Temperature
Resolution:
Accuracy:
±0.02ºF (0.01º C)
±2.34ºF/ ±1.3ºC
(over a -40ºC to +70ºC / -40ºF to 158ºF)
Hazardous Class I, Division 1, Group D
Temperature Detection
Measurement:
Methodology:
Range:
Five (5) equally spaced RTDs for volumetric
measurement
STANDARD: -4ºF to 158ºF (-20ºC to 70ºC)
X-TENDED TEMP: -40ºF to 158ºF (-40ºC to 70ºC)
24 V Barrier Part number 20-4345
Requires one (1) I.S. barrier position per probe
Five temperature sensors reside in the probe shaft for measuring
product temperature at different levels in the tank. They are located at
positions of approximately 20%, 40%, 60% and 80% of the tank’s
volume. The sensors feed the data of the temperature of the fuel to
the console. The console software is then able to make the
calculations to produce a net corrected product volume.
Figure 12-2 Model
EECO Probe
To Next Page
Loading...
