Dover OPW SiteSentinel iSite - 5.18 Density Measurement Sensor (DMS)

Page 58 of 145
www.opwglobal.com
5.18 Density Measurement Sensor (DMS)
Part No. 30-3232
The Density Measurement Sensor (DMS) (Figure 5-20) installs on the
pre-existing probe and continuously measures the average density of
the fuel in the tank. This provides a measure of even the smallest
change in product density within the API density range. Fuel-density
reports can be displayed real-time on the console or exported to an
external device. The readings can be either nominal or temperature-
corrected density.
Density Measurement Sensor
Materials:
Nitrophyl, Delrin, and Stainless-Steel spring
Resolution:
0.00004 g/cc
Accuracy:
+/- 0.0025 g/cc
Density Range:
0.6 – 1.0 g/cc
Operating Temperature:
-40°F to 158°F (-40°C to +70°C)
Dimensions:
Length: 11” (27.9 cm), Diameter: 2” (5.1 cm)
Sensors per Barrier:
16 maximum
Suggested Location:
6” (15.2 cm) from bottom of probe)
Note: Use set screw at top and bottom of
sensor to hold in position
Figure 5-20 Density Measurement Sensor