Dover OPW SiteSentinel iSite - Installation Overview

146 pages

To Next Page

To Previous Page

Page 66 of 145

www.opwglobal.com

Figure 7-2 LIM System Overview

Typical FE Petro Connection

7.1.1 Installation Overview

Installation may vary depending on your submersible pump

manufacturer; therefore, installation overview may vary from site to

site.

Figure 7-2 Variable Speed Control Wiring for FE Petro

Figure 7-4 Typical FE Petro Wiring Connections

Main Page

Default Chapter3
- Table of Contents3
1 Before You Begin10
- Installer Safety10
- Precision Leak Test10
- Initial Inspection10
- Manifolded Tanks10
2 System Overview11
- Sitesentinel® Isite™ Console11
  - Blank Door Unit11
- Network Connections12
  - DHCP and Static IP Connections12
  - Direct Connections13
- Peripheral Connections14
- The Vsmart Module18
  - Vsmart Module Connections20
  - Vsmart & I/O Module AC Wiring20
- Tank Alert Modules26
  - Tank Alert Wiring26
- Internal Printer28
  - Installation Procedure28
3 Tank Preparation29
- Probe Placement29
- Probe Installation in Underground Tanks30
  - Calculating Product Offset31
4 Probe Installation32
- Adaptor Collar & Riser Cap32
- Probe Floats32
- Model 924B Probes35
- Flex Probe Installation37
5 Sensors41
- Intellisense™ Technology41
- Multi-Drop Installation41
- Interstitial Level Sensor Float Switch42
- Single-Level Sump Sensor43
  - Installation43
- Universal Sump Sensor44
  - Installation44
- Liquid-Only Float Sensor45
  - Installation45
- Discriminating Dispenser Pan Sensor46
  - Installation46
- Discriminating STP Sump Sensor47
  - Installation47
- Hydrocarbon Vapor Sensor48
  - Installation48
- Discriminating Interstitial Sensor49
  - Installation49
- Interstitial Hydrocarbon Liquid Sensor with Water Indicator50
- Hydrocarbon Liquid Sensor with Water Indicator51
- Interstitial Sensor52
  - Interstitial Sensor Installation52
- Dual-Float Dispenser Sump Sensor53
- Dual-Float STP Sump Sensor54
- Dual-Float Brine Sensors55
  - Dual-Float Brine Sensor (D-10)55
  - Dual-Float Brine Sensor (D-20B)56
- Reservoir Sensor Installation57
- Density Measurement Sensor (DMS)58
6 Leak Detection63
- Volumetric Line Leak Detector (VLLD) Sensor63
  - Prior to Installation63
  - Installation64
7 Line Interface Module (LIM)65
- Installation Overview66
8 Conduit & Cabinet Installation68
- Console Installation68
- Vsmart Module Installation69
- Line Interface Module (LIM) Installation69
- Probe & Sensor Conduits70
  - Circuit Breaker Conduits70
  - Communications Conduits70
- I/O Device Conduits71
9 Sensor Installation72
- Introduction72
- Dry-Well Monitoring, Single-Wall Tank73
- Wet-Well Monitoring, Single-Wall Tank75
- Well Monitoring, Double-Wall Tank76
- Double-Wall Tank with Well Monitoring77
10 Probe-Cable Seal-Offs79
11 Other System Parameters80
- Vsmart Module Petro-Net™ Addressing80
12 Installation with Existing OPW/EECO Equipment81
- Model 924A Probes81
- Model EECO Probes82
- Sitesentinel® Isite™ Smart Module83
- Waterproof Field Electrical Connections84
13 Acr/Rim85
- Prior to Installation86
- Installation Procedure86
  - ACR/RIM Hardware Installation87
  - ACR/RIM Board Jumper Setup89
Appendix A: Model 924B Probe Part Numbers91
Appendix B: Output Relay Installation Report92
Appendix C: Sensor Labels94
Appendix D: 7100V Flex Probe Installation Records96
Appendix E: Model 924B Probe Installation Records98
Appendix F: Icon Glossary100
Appendix G: Maintenance Functions120
- Use of Maintenance Kit120
- Backup and Restore of Configuration & Backup Database121
- Connecting Directly Via Crossover Cable122
- Connecting USB Keyboard122
Appendix H: OM4 Output Module for Sitesentinel Isite123
- Codes124
  - Hazardous Area Definition124
- Connections124
Appendix I: Sitesentinel and EMCO Sensors Without Intellisense™ Board125
- Hydrocarbon Liquid/Water Sensor125
- Hydrocarbon Vapor Sensor126
- Combo Single Level / Hydrocarbon Liquid Sump Sensor127
- Combo Dual Level/ Hydrocarbon Liquid Sump Sensor128
- Single Level Sump Sensor129
- Dual Level Reservoir Sensor130
- Interstitial Level Sensors131
- Hydrocarbon Liquid Sump Sensor132
- Interstitial Optical Liquid Sensor133
Appendix J: Console Boards134
Appendix K: System Functional Testing137
Appendix L: Annual Inspection Checklist140
- Declaration of Conformity142
- Index144
- Notes146

Dover OPW SiteSentinel iSite - Installation Overview

Table of Contents

Related product manuals