13
ACR/RIM
The ACR/RIM collects pump transaction data from electronic pumps to
provide the OPW tank gauges required data for auto-recalibration and
reconcile transactions against tank inventories.
•
ACR - Automatic Calibration and Reconciliation
•
RIM - Reconciliation Interface Module
Due to the flexibility of the system and the unique nature of every site,
it is not possible to show every possible installation scenario.
Local codes may dictate specific installation requirements. Installation
is subject to approval by the local authority having jurisdiction at the
site.
The system installation instructions are the same for all ACR/RIM
systems. Specific differences between the systems are noted within
the text.
These Installation instructions are for a typical installation.
Do not mount your system site controller, or any other electrical part of
the system, including printers and modems, within or above the defined
"hazardous" areas.
Figure 13-1 ACR/RIM Enclosure (inside view)
Installation Codes
•
Any fuel dispenser is a hazardous area as defined in the
National Electrical Code. Installation must be in
accordance with the following:
•
National Electrical Code NFPA No.70 Automotive and
Marine Service Station Code (NFPA No. 30A). The installer
is responsible for investigating and following any local
codes applicable in the country of installations.
Hazardous Areas
•
ACR/RIM is listed for use in a non-classified area. All of the
equipment must be installed outside of the hazardous
areas.
To Next Page
Loading...
