Dover OPW SiteSentinel iSite - 13.2.2 ACR;RIM Board Jumper Setup

Page 89 of 145
www.opwglobal.com
13.2.2 ACR/RIM Board Jumper Setup
Setup jumpers to match pump type being connected. When a
jumper is set as ON, this means the jumper will tie both pins
together. When OFF, the jumper should be set on one pin.
Some jumpers have three pins, when the jumper says pins 1-2
this means the jumper should be set on pins 1 and 2 of the
three-pin jumper. On three-pin jumpers, the board is labeled
which pin is number one (see Figure 13-7).
Jumper #
Pins
Function
Pump Type
Gilbarco
Wayne
J2
1-2
N/A
OFF
J3
1-2
N/A
ON
J4
1-2
N/A
ON
J5
1-2
N/A
ON
J6
1-2
N/A
ON
J7
1-2
RTS/CTS Loopback
OFF
J8
1-2
Loop Mode
OFF
J9
1-3
Loop Mode
ON
J10
1-3
Loop Mode
Pins 2-3
J11
1-2
ECHO-Enabled
OFF
ON – FSC3000 controller
OFF – NO
ON – FSC3000 controller
J12
1-2
Current Selection
ON (45 mA)
OFF (34mA)
J14
1-2 & 3-4
Normal
ON
Erase Non-Volatile
OFF
5-6
Liters
ON
Gallons
OFF
7-8
Totalizers SUMM
OFF
Totalizers SUMM
ON
J16
N/A
OFF
J17
N/A
OFF
J18
N/A
ON
J19
N/A
OFF
J20
N/A
OFF
J22
COMM Mode
Pins 1-2 (RS232)
J23
COMM Mode
Pins 1-2 (RS232)