RS4203 Operating Manual Chapter 7 - Recipe Descriptions
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 44
Operating
Parameters/Features
Used to enable the pieces/shirr counter.
9
If OFF, allows the punch to extend more
quickly. If ON, provides an air cushion to
slow the extension of the punch. More
fragile casings may require the cushion.
On or Off On
Turns the STRING LOOPER ON or OFF
11
CONTINUOUS LOOPS
(ON/OFF)
Used to place a loop on every chub
regardless of knife cycle. (Looper must
On or Off Off
12
Turns the TRIP PADDLE ON or OFF.
When ON, the trip paddle initiates the clip
On or Off On
13
Used to enable the 4203 internal portion
timer.
On or Off Off
14
Turns The FILL LAG feature ON or OFF.
(FILL LAG COMPENSATE is used to
send the start signal to the filler, before
the voider plates fully retract. This allows
the operator to adjust the point in the clip
cycle when the product begins to flow.
The FILL LAG COMPENSATE “time”
should initially be set at a large value and
gradually decreased until the desired
Filler start timing is reached.)
On or Off Off
15
If “ON” locks the skin brake in the forward
On or Off Off
16
If “ON” causes the skin brake to move to
the clip position AFTER the voiders have
closed. If “OFF” the skin brake will move
to the clip position as the voiders are
On or Off Off
17
Enables registration software, which
enables the registration sensor to sense
and detect the Indicator mark and
subsequently initiate the clip cycle. Trip
Paddle must also be ON, since the
sensor waits for the trip paddle to begin
Indicator mark detection scan.
On or Off Off
18
Enables a pneumatic output which cycles
at the same time as the electronic filler
On or Off Off
To Next Page
Loading...