Dover Tipper Tie RS4203 - Page 46

RS4203 Operating Manual Chapter 7 - Recipe Descriptions
Rev 32, 01/11/13 Copyright © 2013, Tipper Tie, Inc., All rights reserved 46
Item
Operating
Parameters/Features
Description
Valid Range
Default
26
PUNCH DWELL (SEC)
This Timer is used to adjust a DWELL on
the PUNCH when it is fully extended into
the clip and die. Adjustment is made
according to the product being run.
0.00s to 1.00s 0.20s
27
FILL LAG COMP (SEC)
Adjustable time that allows the start
signal to the filler BEFORE the clip cycle
is complete. (FILL LAG COMP must also
be enabled.)
0.00s to 2.00s 1.00s
28
PORTION TIME (SEC)
Length of time the FILLER IS ON when
the Internal portion-timer option is ON.
0.00s to 30.00s 1.00s
29
RUN ON DELAY (SEC)
An adjustable timer controlling the
amount of time between the end of the fill
cycle and the beginning of the clip cycle.
0.00s to 5.00s 0.00s
30
FILLER MAX TIMEOUT
(SEC)
This parameter determines the maximum
time the Start-Filler output will remain ON
between clip cycles if no signal to clip is
ever received.
1.00s to 180.00s 180.00s
31
RESET FILLER PULSE
-
WIDTH (SEC)
This parameter controls the amount of
time the Start-
Filler output signal is “OFF”
between multi-portion fill cycles. Value
will depend on individual filler
requirements. (Note: When the Multi-
Portion Counts parameter is greater than
1, some fillers require the RS4203's
Start-Filler output to turn off and back on
to allow the filler to pump again)
0.00s to 1.00s 0.00s
32
SKIN BRAKE DELAY (SEC)
A timer which controls the amount of time
between the start of the fill cycle and the
movement of the skin brake to the fill
position.
0.00s to 32.00s 0.10s
33
CONVEYOR HI SPD TIME
OUT
An adjustable timer which limits the
amount of time the conveyor may run at
high speed.
1.00s to 300.00s 5.0s
34
KNIFE EXTEND DWELL
Parameter to control the amount of time
the knife is extended when cutting.
0.10s to 0.50s 0.10s
35
KNIFE RESET DWELL
Parameter to control the amount of time
the knife must stay retracted before
extending again when the Multi-Cut
Cycles parameter is greater than 1.
0.10s to 0.50s 0.10s
36
EYE
-MARK DETECTION
TIME
The maximum time allowed for the
detection of the registration Indicator
mark, after the product has reached the
trip paddle. If this time expires without
Indicator mark detection, the filler will be
stopped and a clip cycle initiated.
0.00s to 20.00s 0.20s