Instructions for use | Atlan A100 (XL), A300 (XL), A350 (XL) SW 2.1n 135
Tests
With Infinity ID function:
– Absorbers of type Infinity ID CLIC Absorber will be detected automatically.
The replacement date will be set automatically.
Without Infinity ID function:
– Absorbers will not be detected, e.g., reusable CO
2 absorbers.
● Update the replacement date manually: Touch the Reset button after the
soda lime has been replaced.
Only perform the system test or leakage test with the CLIC absorber locked
into place because the CLIC absorber affects the system compliance values.
7.5.6.2 Sample line port
Prerequisite: The device is equipped with "Integrated O
2 monitoring".
● Seal the port for the sample line at the Y-piece.
50003