Vigor2620 Series User’s Guide
318
2. After you click the Edit link, you will see the following page. Now you can define the
name for that Class. In this case, “Test” is used as the name of Class Index #1.
3. For adding a new rule, click Add to open the following page.
Available settings are explained as follows:
Item Description
Enable Check this box to invoke these settings.
Ethernet Type Please specify which protocol (IPv4 or IPv6) will be used for
this rule.
Local Address Click the Edit button to set the local IP address (on LAN) for
the rule.
To Next Page
Loading...
Need help?
General
