Vigor2920 Series User’s Guide
93
3. Go to LAN-to-LAN. Click on one index number to edit a profile.
4. Set Common Settings as shown below. You should enable both of VPN connections
because any one of the parties may start the VPN connection.
5. Set Dial-Out Settings as shown below to dial to connect to Router A aggressively with
the selected Dial-Out method.
If an IPSec-based service is selected, you should further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-Out
connection.
To Next Page
Loading...
Need help?
General
