Vigor2920 Series User’s Guide
151
4
4
.
.
2
2
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
This page provides you the general settings for LAN. Click LAN to open the LAN settings
page and choose General Setup.
There are four subnets provided by the router which allow users to divide groups into different
subnets (LAN1 – LAN4). In addition, different subnets can link for each other by configuring
Inter-LAN Routing. At present, LAN1 setting is fixed with NAT mode only. LAN2 – LAN4
can be operated under NAT or Route mode. IP Routed Subnet can be operated under Route
mode.
Each item is explained as follows:
Item Description
General Setup-----
Allow to configure settings for each subnet respectively.
Index - Display all of the LAN items.
Status- Basically, LAN1 status is enabled in default.
LAN2, LAN3, LAN3 and IP Routed Subnet can be
observed by checking the box of Status.
DHCP- LAN1 is configured with DHCP in default. If
required, please check the DHCP box for each LAN.
IP Address - Display the IP address for each LAN item.
Such information is set in default and you can not modify it.
Details Page - Click it to access into the setting page. Each
LAN will have different LAN configuration page. Each
LAN must be configured in different subnet.
IPv6 – Click it to access into the settings page of IPv6.
Force router to use “DNS
server IP address”
settings as specified in …
Force Vigor router to use DNS servers configured in
LAN1/LAN2/LAN3/LAN4 instead of DNS servers given
by the Internet Access server (PPPoE, PPTP, L2TP or
DHCP server).
To Next Page
Loading...
Need help?
General
