Vigor2920 Series User’s Guide
221
Available settings are explained as follows:
Item Description
Name
Type a name for this profile. Maximum 15 characters are
allowed.
Address Type
Determine the address type for the IPv6 address.
Select Single Address if this object contains one IPv6
address only.
Select Range Address if this object contains several IPv6s
within a range.
Select Subnet Address if this object contains one subnet
for IPv6 address.
Select Any Address if this object contains any IPv6
address.
Select Mac Address if this object contains Mac address.
MAC Address
Type the MAC address of the network card which will be
controlled.
Start IP Address
Type the start IP address for Single Address type.
End IP Address
Type the end IP address if the Range Address type is
selected.
Subnet Mask
Type the subnet mask if the Subnet Address type is
selected.
Invert Selection
If it is checked, all the IPv6 addresses except the ones listed
above will be applied later while it is chosen.
3. After finishing all the settings here, please click OK to save the configuration.
To Next Page
Loading...
Need help?
General
