Vigor2920 Series User’s Guide
384
Set Community
Set community by typing a proper name. The default setting
is private.
Manager Host IP (IPv4)
Set one host as the manager to execute SNMP function.
Please type in IPv4 address to specify certain host.
Manager Host IP (IPv6)
Set one host as the manager to execute SNMP function.
Please type in IPv6 address to specify certain host.
Trap Community
Set trap community by typing a proper name. The default
setting is public.
Notification Host IP
(IPv4)
Set the IPv4 address of the host that will receive the trap
community.
Notification Host IP
(IPv6)
Set the IPv6 address of the host that will receive the trap
community.
Trap Timeout
The default setting is 10 seconds.
Enable SNMPV3 Agent
Check it to enable this function.
USM User
USM means user-based security mode.
Type a username which will be used for authentication.
Auth Algorithm
Choose one of the encryption methods listed below as the
authentication algorithm.
Auth Password
Type a password for authentication.
Privacy Algorithm
Choose one of the methods listed below as the privacy
algorithm.
Privacy Password
Type a password for privacy.
Click OK to save these settings.
To Next Page
Loading...
Need help?
General
