Vigor2920 Series User’s Guide
62
Note: Only one WAN interface support IPv6 service at one time. In this example,
WAN2 is chosen as the one supporting IPv6 service.
2. In the following figure, click Enable and type the required information. Click OK to save
the settings and return to previous setting page.
3. Click IPv6.
4. In the following figure, use the drop down list to choose a proper connection type.
Different connection types will bring out different configuration page. Refer to the
following:
PPP – Dual Stack application
Choose PPP to access into the setting page for IPv6 service. It is not necessary for you to
configure anything.
To Next Page
Loading...
Need help?
General
