Vigor3900 Series User’s Guide
209
as Auth Type.
Security Protocol
Choose ESP to specify the IPSec protocol for the
Encapsulating Security Payload protocol. The data will be
encrypted and authenticated. Choose AH to specify the
IPSec protocol for the Authentication Header protocol. The
data will be authenticated but not be encrypted.
WAN Profile
Choose a WAN profile to be used by such profile.
Local IP/Subnet
Mask
Type the IP address and subnet mask of local host.
Local Next Hop
Specify the gateway for WAN interface. Usually, use the
default setting (leave it in blank).
Remote Host
Type the WAN IP address for the remote host.
Remote IP / Subnet
Mask
Type the LAN IP address and LAN subnet mask for the
remote host.
More Remote
Subnet
Add more remote subnet in this field if required.
Local GRE IP
The virtual IP address of the router, specified for this tunnel.
Remote GRE IP
The virtual IP address of the remote client, specified for this
tunnel.
5. Fill in the required information on this page and click Finish. Later, the system will ask
if you want to display the new created VPN file.
To Next Page
Loading...
Need help?
General
