Vigor3900 Series User’s Guide
62
Apply
Click it to save the configuration and exit the dialog.
Cancel
Click it to exit the dialog without saving the configuration.
z If you choose DHCP as IPv4 protocol type, click the DHCP Tab to open the
following page:
Available parameters are listed as follows:
Item Description
Host Name
(Optional)
Type a name as the host name for identification.
IP Alias
Type other IP addresses to be bound to this interface. This
setting is optional. If you have typed addresses here, you can
see and choose it in later web page settings (e.g.,
NAT>>Port Redirection/DMZ Host).
To add a new IP address, click Add. Type the IP address and
use the drop down list to specify the subnet mask. Next,
click Save. The new one will be added and displayed on the
field under the box.
Add – click this button to have a field for adding a new IP