38
(encryption) function of VigorAP 802 is properly configured, you can
see ‘Yes’ message here.
WPS SSID Display current SSID.
WPS Auth Mode Display current authentication mode of the VigorAP 802. Only
WPA2/PSK and WPA/PSK support WPS.
WPS Encrypt Type Display encryption mode (None, WEP, TKIP, AES, etc.) of VigorAP 802.
Configure via Push
Button
Click Start PBC to invoke Push-Button style WPS setup procedure.
VigorAP 802 will wait for WPS requests from wireless clients about two
minutes. Both ACT and 2.4G WLAN LEDs on VigorAP 802 will blink
quickly when WPS is in progress. It will return to normal condition
after two minutes. (You need to setup WPS within two minutes)
Configure via Client
PinCode
Type the PIN code specified in wireless client you wish to connect, and
click Start PIN button. Both ACT and 2.4G WLAN LEDs on VigorAP 802
will blink quickly when WPS is in progress. It will return to normal
condition after two minutes. (You need to setup WPS within two
minutes).
II-3-5 Advanced Setting
This page is to determine which algorithm will be selected for wireless transmission rate.
Available settings are explained as follows:
To Next Page
Loading...
Need help?
General
