87
III-1-9 Management
This page allows you to specify the port number for HTTP and HTTPS server.
Available parameters are explained as follows:
Item Description
Device Name The default setting is VigorAP 802. Change the name if required.
Access Control Allow management from WLAN - Enable the checkbox to allow
system administrators to login from wireless LAN.
Enable Telnet Server– The administrator / user can access into the
command line interface of VigorAP remotely for configuring settings.
Access List Enable access list – Check the box to specify that the system
administrator can only login from a specific host or network defined in
the list. A maximum of five IPs/subnet masks is allowed.
Port Setup HTTP port/HTTPS port -Specify user-defined port numbers for the
HTTP and HTTPS servers.
Panel Control Disable LED - The LEDs blink always since VigorAP is powered on.
Some people might not like that. Therefore the function of LED is
allowed to be disabled to make people feeling comfortable and
undisturbed. After checking it, all the LEDs on VigorAP will light off
immediately after clicking OK.
Enable Default Configuration Wizard – Default setting is enabled.
To Next Page
Loading...
Need help?
General
