Draytek VigorAP 802 User Manual

47
II-3-11 Roaming
The network signal for a single wireless access point might be limited by its coverage range.
Therefore, if you want to expand the wireless network in a large exhibition with a quick method, you
can install multiple access points with enabling the Roaming feature for each AP to reach the
purpose of expanding wireless signals seamlessly.
These access points connecting for each other shall be verified by pre-authentication. This page
allows you to enable the roaming feature and the pre-authentication.
Available settings are explained as follows:
Item Description
AP-assisted Client
Roaming Parameters
When the link rate of wireless station is too low or the signal received
by the wireless station is too worse, VigorAP 802 will automatically
detect (based on the link rate and RSSI requirement) and cut off the
network connection for that wireless station to assist it to connect
another Wireless AP to get better signal.
Minimum Basic Rate – Check the box to use the drop down list to
specify a basic rate (Mbps). When the link rate of the wireless station
is below such value, VigorAP 802 will terminate the network
connection for that wireless station.
Disable RSSI Requirement - If it is selected, VigorAP will not
terminate the network connection based on RSSI.
Strictly Minimum RSSI - VigorAP uses RSSI (received signal strength
indicator) to decide to terminate the network connection of wireless
station. When the signal strength is below the value (dBm) set here,
VigorAP 802 will terminate the network connection for that wireless
station.
Minimum RSSI - When the signal strength of the wireless station is
below the value (dBm) set here and adjacent AP (must be DrayTek AP
and support such feature too) with higher signal strength value

Draytek VigorAP 802 Specifications

General

Brand	Draytek
Model	VigorAP 802
Category	Wireless Access Point
Language	English