Draytek VigorAP 802 - Page 72

66
 It is not suggested to use a wireless Mesh Node with Ethernet cable connected to a Mesh Root.
 If resetting a Mesh Root,
- All "connected" Mesh Nodes will be informed to reset.
- Group List and Group Key will be reset, too.
- For those Mesh Nodes unable to reset, reset them manually. Reset the Group List by web
or factory default.
 If resetting a Mesh Node,
- Group List and Group Key will be cleared.
- Link Status will become "New".
 Mesh network status also can be viewed and checked through the dashboard by clicking MESH
NETWORK.
 If Mesh Search / Apply / Discover is worked too fast or is done with empty result, your request
may be rejected. Please try again.
 Troubleshooting:
- Check the firmware version. Please make sure all APs within the mesh group are in the
newest firmware version.
- Check the OP (operation) Mode. Make sure new Mesh Node doesn't accidentally get DHCP
IP and becomes AP mode.
- Check the country code and channels. For example, it is impossible for connecting a
VigorAP 802 Mesh Node with 5G channel 36 to VigorAP920R Wireless Mesh Root in EU
country code.
- Check the channel load. Make sure it is not over 70%.
- Collect some Mesh logs and send the result to DrayTek for analyzing.