10
P R O G R A M M I N G
Label 001: Number Command 2, Ordered Form.
The number will be announced in a descriptive
form. For example, the number 401 would be
announced as
“four hundred and first”
.
Label 002: Number Command 3, Individual
Numbers. Each digit in the number will be
announced individually. For example, the number
401 would be announced as
“four zero one”
.
The number commands take up two of the six
available word spaces in a label. In the first space
select the type of announcement for the number
(Number Command 000, 001 or 002). In the second
space program the 3-digit number to be read (from
000 to 999).
Because number commands take up 2
label spaces, you cannot program them
in the sixth entry spot for a label.
○○○○○○○○○○○○○○○○○○○○○○○○○
Automation Item Labels ..Sections [451] - [482]
Mode Labels....................Sections [521] - [528]
Command Output Labels Sections [545] - [548]
Partition Labels ............... Sections [561] - [562]
○○○○○○○○○○○○○○○○○○○○○○○○○
Zone Labels..................... Sections [601] - [633]
3.5 Reviewing Programming
To review the current programming for a section
enter the 3-digit section number. The Escort5580
will announce the data programmed. If the
programming is correct press [#] to exit the section,
otherwise enter the correct data.
3.6 Exiting Programming
When the Escort5580 announces
“Enter Section“Enter Section
“Enter Section“Enter Section
“Enter Section
Number”,Number”,
Number”,Number”,
Number”, press the [#] key.
To Next Page
Loading...
Need help?
General
