DSC Touch-SCW9067

INSTALLATION
CLEAR DEVICE
FIND IT
Settings
Installation
Installer Code Access
Master Code Access
Home Control
Devices
Clear Device
Clears Z-Wave device from a network, whether it was enrolled with another
controller previously or the DSC Touch.
Touch
“Clear Device”
Panel will start sending a
“Clear” signal
Press
“Pair” or “Learn”
button on device*
Note: each Z-Wave device is different, and not all devices have a hard button to pair or learn.
Refer to your device’s installation manual for specifics on pairing or learning.
Panel returns to
Home Control
Device menu
when complete
DSC Confidential and Proprietary Page of 48 114
© Last updated 4/29/15 All rights reserved