Installer Code Access
Master Code Access
DSC Confidential and Proprietary Page of 65 114
© Last updated 4/29/15 All rights reserved
When enabled, dual path connectivity allows the DSC Touch to use both
cellular and Wi-Fi radios for signals and communication simultaneously.
By default Dual-Path Control is
enabled. To disable, “un-check”
the box.
You can also run a Wi-Fi test to
ensure that the Dual Path is
connecting properly. Unlike
the standard Wi-Fi test (which
checks connection to the
router) the panel will check its
connection all the way back to
Alarm.com.
*Note: The DSC Touch must be connected to a wi-fi network to enable Dual Path
SCW9067C and SCW9067H are compatible with the following UL/ULC listed monitoring station receivers: SG-
System I/II/III/IV/5. NOTE: Wi-Fi is for supplemental use only for UL/cUL
To Next Page
Loading...
